For sale is a terraced house with a modern building shape located in a prestigious district of Mikołów - Kamionka, on Czereśniowa Street. The house has an area of 135.54m2 with a plot area of 317.63m2. The garden has an area of 203.35m2. Access to the house is via a paved road. The functionally designed space and bright rooms thanks to large glazing will ensure comfort of use. Technical parameters: FOUNDATIONS - CONSTRUCTION: foundation slab 25cm thick made of concrete B25 (C25/30). External and internal walls for reinforcement - construction. External walls designed in a modular system in wooden construction by Wood Core House. Modules are made of wooden elements from KVH wood with cross-sections of 8 / 6 / 4 on 16 cm covered on one side with a structural board. The height of the wall modules is 275 cm, the width of individual modules is 62.5, 125, 167.5, 250, 312.5 cm respectively. Additionally, double columns made of KVH wood with a cross-section of 8x16 cm were used at the corners of the building and at wall junctions. The columns are also elements of the WCH system. CEILING AND ROOF - CONSTRUCTION: The ceiling above the ground floor and the roof structure are designed with HBSw beams - hybrid system beams in the Wood Core House system with a height of 40 cm, spaced a maximum of 62.5 cm, supported on walls min. 16 cm, connected with structural beams made of KVH 8/30 cm at the installation shaft locations and with BSH beams as reinforcement under the first-floor walls with a height of 40cm and widths of 16 and 20 cm. MOISTURE INSULATIONS: Foundation insulation - horizontal foundation insulation - 2 layers of PE foil 0.3 mm. Vertical foundation insulation - system dispersion mass for asphalt-rubber insulation, connection of the slab with the wooden structure secured with bitumen tape at least 300 mm wide. Floor insulation - 2 layers of PE foil under the layer of polystyrene and a layer of aluminum foil on the layer of polystyrene. Insulation in wet rooms - 2 layers of foil and additionally a cement screed secured with liquid insulation foil. Wall insulation - vapor barrier foil. On the outside, on the structural board of the module cladding, a high vapor-permeable wind insulation membrane was used. Roof insulation - vapor barrier foil. On the outside on the OSB board, PE foil. As the top layer, a PVC membrane was used. THERMAL INSULATIONS: Thermal insulation of foundations - foundation slab secured over its entire height with extruded polystyrene (XPS) λmin = 0.032 W/mK; around the building, a frost protection belt made of the same material, 10 cm thick and at least 60 cm wide; the gap between the wall and the plinth is secured with low-pressure insulating foam. Thermal/acoustic insulation of walls - the external wall inside the module is secured with mineral wool λmin = 0.038 W/mK 16 cm; the external wall is secured with non-fluted polystyrene λmin = 0.042 W/mK in places with a thickness of 15cm, 0.038 W/mK in places with a thickness of 10 cm and 0.032 W/mK in places with a thickness of 5 and 8 cm; window and door frames should be covered with at least 3 cm of polystyrene. Internal walls filled with acoustic mineral wool - both partition and. Floor thermal insulation - the floor is secured with EPS100 polystyrene λmin = 0.036 W/mK 14 cm, laid on PE foil, from above the polystyrene is secured with aluminum foil, suitable for underfloor heating; Roof thermal insulation - thermal insulation of the roof structure made of mineral wool λmin = 0.038 W/mK, with a thickness of at least 10 cm in the space between beams, and in the layer directly on the surface of the roof structure with polystyrene 0.042 W/mK 15 cm + sloping wedges 2-17 cm. OTHER - FINISHING ELEMENTS: Floor slab - floor made of cement screed with distributed reinforcement. External plasters and finishing of internal walls and ceilings - internal partition walls made of GK boards on a steel frame, filled with 10 cm thick acoustic mineral wool. In wet rooms, plates with increased water resistance GKBI were used. The ceiling is made of boards anchored directly to the building structure. Joinery - Windows - DECCO EXSTRUSION Type DECCO 83, triple glazing. Heat transfer coefficient 0.9 W/(m2·K). External doors - Delta Specjal - Type Delta SPECJAL 68SL in anthracite color. Heat transfer coefficient 1.3 W/(m2·K). Internal doors - installed individually, doors to sanitary rooms equipped with a ventilation grille with an area of at least 0.022m2 or trimmed; Gas wall-mounted condensing boiler Viteodens 050-W** by Viessmann. I invite you to contact me and for a presentation of the property.

Specifications:
Area: 135.54 m²
Bedrooms: 4
Floor: 1
Built: 2025

Seller: Justyna Pich

Data source: https://www.otodom.pl/pl/oferta/dom-szeregowy-narozny-z-duzym-ogrodkiem-kamionka-ID4xy1L